Power Supplies - Current Solutions, Inc. - Your OEM Power Source Allies

PowerStax APC-FP06/10 PFC Modules

APC-FP06
APC-FP10

600 & 1000 Watt Power Factor Correction Modules

(PDF)

Features

High efficiency of >95%
Conforming to IEC-1000-3-2
Standard full brick package (116.8 x 61 x 12.7 mm)
600 & 1,000 Watt versions
Voltage input range 85 Vrms - 264Vrms
Typical power factor of 0.99
External synchronization facility
Over current protection
Enable signal for downstream converters
Operating Temperature -25°C to +100°C
Thermal protection & Inrush current limiting
Overvoltage protection
DC OK signal provides early warning of mains failure
Two year warranty

Absolute Maximum Ratings
Parameter	Conditions	APC-FP06			APC-FP10			Unit
Parameter	Conditions	Min	Typ	Max	Min	Typ	Max	Unit
Input voltage		0		264	0		264	Vrms
Input voltage	< 1 sec			300			300	Vrms
SYNC to -Vin		-1.2		7	-1.2		7	V
ENABLE to -Vout		-0.3		16	-0.3		16	V
+Vout to -Vout		-0.5		425	-0.5		425	V
DC OK to -Vout		-0.3		16	-0.3		16	V
Vaux to -Vout		-0.3		16	-0.3		16	V
Isolation voltage (in to base)		1500			1500			Vrms
Isolation voltage (out to base)		1500			1500			Vrms
Storage Temperature		-40		100	-40		100	°C
Operating Temperature		-25		100	-25		100	°C
Pin soldering temperature	< 5 sec wave solder		260			260		°C
Pin soldering Temperature	< 7 sec hand solder		390			390		°C

Electrical Characteristics
Parameter	Conditions	APC-FP06			APC-FP10			Unit
Parameter	Conditions	Min	Typ	Max	Min	Typ	Max	Unit
Operating Input Voltage		85		264	170		264	Vrms
Input surge limiting				15			15	A
Operating Input Current	110 Vrms			6.1				Arms
Operating Input Current	230 Vrms			2.9			4.6	Arms
Output voltage Setpoint	230 Vrms, Full load	372.4	380	387.6	372.4	380	387.6	V
Output OVP Setpoint				425			425	V
Output current	At 100°C baseplate temperature	0		1.58	0		2.63	A
Switching Frequency			150			150		kHz
Efficiency	110V nominal input, 25°C base		91			-		%
Efficiency	230V nominal input, base 25°C		95			95		%

Undervoltage turn-on	Increasing Input Voltage		85			170		Vrms
Undervoltage turn-off	Decreasing Input Voltage		81			162		Vrms
Synchronization Frequency		165		180	165		180	kHz

Output Power	APC-FP10 (max power de-rated at 6.7W/V from 200V input to 800W at 170 Vrms)				0		1000	W
Output Power	APC-FP06 (max power de-rated at 6.7W/V from 100V input to 500W at 85 Vrms	0		600				W
Line regulation & load regulation	Low to high input voltage and 10% load to full load	375		400	375		400	V
Temperature regulation	Deviation of output voltage from 25°C		TBD			TBD		%/°C
Ripple	1000uF load capacitor			10			10	V p-p
Current limit				2			3.3	A
Short circuit current limit	Crow bar short circuit		TBA			TBA		A
Enable Threshold	Vout rising		360			360		V
Enable Threshold	Vout falling		230			230		V
DC OK Threshold	Vout rising		360			360		V
DC OK Threshold	Vout falling		350			350		V
Vaux output		14		15	14		15	V
Vaux current		0		10	0		10	mA

Length			116.0			116.0		mm
Width			61			61		mm
Height			12.7			12.7		mm
Thermal Resistance	Base to heat sink, fitted with thermal pad		0.1			0.1		°C/W
Weight	Approx		170			170		gms

Overtemperature shutdown		100	105	110	100	105	110	°C
Isolation voltage (in to base)	Complies with basic insulation requirements	1500			1500			Vrms
Isolation voltage (out to base)	Complies with basic insulation requirements	1500			1500			Vrms
Isolation capacitance	Input to base		TBA			TBA		pF
Isolation resistance	Input to base		100M			100M		Ohms
Agency approvals	Nemko, CSA, US & Canada - Others per customer requirement

APC-F203 Series Specifications
Model Number	Input Voltage (V)	Output Voltage (V)	Output Power (W)
APC-FP10-230-C30	230Vac	380Vdc	1000
APC-FP06230-C30	110/230Vac	380Vdc	600